Homemade Conquest Hardtop Build Thread

[guyvapeur]

Something caught my eye when I first looked at the pictures. On second look, I noticed that skis had been used as strength members but run the length of the roof. I was just thinking that a ski with the front curl cut off would make a fine cross member. They are pre-shaped and stressed to have a bend. Like the big trailer that have a bend to take on the load. That might just be enough to keep the roof from sagging in the middle. They do not weigh a lot and around here, the good will store gives them away come spring.
*****After re-reading your initial piece, what you describe as a rack may in fact be an attempt by the previous owner to support the center portion of the roof to prevent puddling....which is what I mention above.*****
good luck

[riotwarrior]

This is going to be a closely watched thread for sure....

Hope see some video of this machine in action....

Thanks for sharing.

[thorn]

2014-03-09 11.43.39.jpgI am interested in seeing this transform. I live in Utah, but I bought my Conquest in Colorado and it appears I have the same top with soft sides, but I want to see how the hard sides turn out. I love the top and my top is sealed/enclosed in aluminum and has not had the leakage (knock on wood). Those tracks must do well in the deep snow. Did you have the soft sides on the hard top?

[bluebruin]

I live in Conifer, CO, at 8200ft. But our cabin, which we need the argo for access, is at 11,000ft right at treeline, below mt sherman near fairplay, CO. its winter is usually -20 to 20 deg and WINDY most the time so I think an enclosed cab will be great.

[guyvapeur]

I am always interested in seeing a build....Given that you already have the cube built, you are well on your way to having a comfortable cab... The snow in your pics tells me you live in an area where a dry warm place to sit is sometimes desireable. Good Luck... Keep up the pics...

[bluebruin]

photo of the insulation after tearing off the "rack" and FRP panel


Here is the trough under the insulation.

[bluebruin]

This will be a build thread for enclosing the aluminum hardtop on my argo with windows and doors.

Its an Argo Conquest 8x8. I bought it this fall. It has an aluminum hardtop that came as an option when the original owner bought it at the dealer (I was told). Here is what it looks like:



The guy i bought it from, attempted to waterproof the roof. The original hardtop is a square tube aluminum frame, but the aluminum skin is on the underside of the frame, so snow and ice built up in the trough's on the on top, causing him issues. He put 1.5" eps foam insulation in the troughs and then covered the whole top with FRP fiberglass panels (the kind you buy from home depot to put on a commercial bathroom wall). Then, at some point, he added a "roof rack" made of old skis. He must have had some leaks along the center of the roof, because he used two FRP panels and that's where they joined. So looks like the whole thing was slathered in roofing tar and spray painted white. The edges and screws were covered in some type of white mastic or goop. Very ugly.


I will be replacing this roof when I build the new enclosed cab.

Here is how it sits now:


Here is what it will look like:


I plan to use 12mm baltic birch plywood, and then polycarbonate for the windows.