Dan67's Hustler 950 Rebuild

[amphibious drew]

Just a little update.. Ordered new tires and hope to have them mounted for Busco..

Hey that's not a proper update Dan! What tires did you buy???

[Dan67]

Hey that's not a proper update Dan! What tires did you buy???

You'll just have to come to Busco and see

[amphibious drew]

You'll just have to come to Busco and see

Oh I will be there.

[fmints]

Hey that's not a proper update Dan! What tires did you buy???

I agree with Drew,, you have to do better than that buddy!!! LOL!! I'll see you there!!

[lewis]

Sorry to hear about the camera Dan New Christmas present

Machine is going to look great with the new tires!

[Dan67]

I agree with Drew,, you have to do better than that buddy!!! LOL!! I'll see you there!!

OK I guess I need to provide a pic. Tires arrived today via Fedex.

[ARGOJIM]

Looks like somebody's been watching videos of missed rides.

[mudbug3]

Dan67


Are those the new Vendetta tires?

[Dan67]

Are those the new Vendetta tires?

Yes they are the new Vendetta tires from Muddox. I am using existing 12x10.5 rims and I had to order 2" wheel spacers because the left rear tire is rubbing the body on the engine clutch extension.

[Dan67]

Upgrade 2014

Started upgrading to new splined axles from whipper. For now I am doing the center axles that drive the machine. I broke way too many shoulder bolts at busco and it was a down right buzz kill. At the same time I am upgrading to new Argo HDI bearings and flanges on the outer bearings. Whipper was kind enough to machine a drill guide that is just perfect. Got bearings from Buffalo Bearings and HDI parts from Tim at Adair. Local Fastenal now carries zinc coated grade 8 bolts, washers, & nuts. Been busy morning sofar, center axles removed without much problems. Now onto pulling the motor so I can get the broken left rear out and swapped with an older center axle.

[green]

That is awesome Dan. I would love to use that jig when I'm ready for it if you wouldn't mind.

[fmints]

Started upgrading to new splined axles from whipper. For now I am doing the center axles that drive the machine. I broke way too many shoulder bolts at busco and it was a down right buzz kill. At the same time I am upgrading to new Argo HDI bearings and flanges on the outer bearings. Whipper was kind enough to machine a drill guide that is just perfect. Got bearings from Buffalo Bearings and HDI parts from Tim at Adair. Local Fastenal now carries zinc coated grade 8 bolts, washers, & nuts. Been busy morning sofar, center axles removed without much problems. Now onto pulling the motor so I can get the broken left rear out and swapped with an older center axle.

Great idea you have there Dan, going with the HDI Bearings!! It really looks stout!! You will be absolutely amazed at how more aggressive you can drive now, knowing that you will not shear any more pins,,,, well at least not on the centers for now!!!!! Looks good Dan, courtesy of Whipper!!!

[Dan67]

Started working on phase II of my upgrades. Got 4 new axles and sprockets from whipper. Will replace remaining bearings to Argo HDI standard. Also replacing inner bearing flanges to cast flanges. Bolts right up to existing holes. Inner are SBLF205-16. Buffalo bearing is the place.

[john swenson]

hey dan, take some pictures of yourself also during the build so we can see the smiles get bigger !! john boy va.

[Dan67]

Got a bit more done today. Fronts are now HDI. Removed the center HDI and bearings. Replaced bearings. Cleaned axles and painted them. Slowly getting it done.