1970 action age scrambler homemade tracks

[jerseybigfoot]

That engine would work fine or powerhouse 12 if you want to modify the engine mount to lift the engine up.
Powerhorse 414cc OHV Horizontal Engine | Powerhorse Engines | Northern Tool + Equipment
The axle hubs are a problem. It takes time, heat, hammer and a gear puller. I started by soaking with PB blaster and hammering the od of the hub with the ball end of a Ball-peen hammer. Some people just use an abrasive zip wheel and cut them axially and weld them back up later.

[Spencer11]

i saw that that engine when i was looking. i am a welder so i can build anything. the problem with that one is that it dosent have electric start which i really want. what kind of clutch should i use with that engine? if i put the engine where the old one was on the right side how do you pull it over. i figure that i can just put it on the left side if i have to.