T-20 rebuilt stick adjustment amount of movement

[boyerbl]

I just finished installing my rebuilt T-20 and after attaching the springs to the control levers. My movement seems to be between 4 to 5 inches. The manual says there should be between 6 and 10 inches of movement. What is the correct amount for a rebuilt T-20? How do I test it?

[egoperf]

That's fine. 6 to 10 is way too much

[racerone3]

That's fine. 6 to 10 is way too much

as long as the T-20 is functioning correctly and the throw is the same on both sticks, there is no real "correct". it is just a matter of finding where it is comfortable for you. I run mine as tight as i can

[ARGOJIM]

I believe the recommended throw varies by model,make of machine. 6-10 is for a iv if I remember correctly, 4-5 is a II as I recall?

[racerone3]

I believe the recommended throw varies by model,make of machine. 6-10 is for a iv if I remember correctly, 4-5 is a II as I recall?

that would make sense as the length of the actual laterals would change the throw

[jerseybigfoot]

I just finished installing my rebuilt T-20 and after attaching the springs to the control levers. My movement seems to be between 4 to 5 inches. The manual says there should be between 6 and 10 inches of movement. What is the correct amount for a rebuilt T-20? How do I test it?

The "U" channel trans is next to impossible to over tightened due to how it's adjusted.

[Toys4Me]

I use the adjustment tool and have never had an issue.