T-20 wont shift

[Mike]

Do the pins screw out or are they press fit??

see racerone3's previous post:

you can replace just the pins. they are about $5-8 from recreative. put the diamond in a vice, remove the O-ring, heat the barrel of the shifter with a propane torch, grab the pin with vice grips and twist/ yank it out. if the other side of the pin is in good shape you can just flip it over and reuse. i install mine with a drop of red loctite

[Mike]

Found the receipt from R.I. They must either like me or dislike you Brian. LOL
Are you sure you didn't make them mad? Did they try to sell you a knueton valve for the fitzajig?

I think you are right buggyman1, here is a receipt of racerone3's that I just found online. Looks like there is a premium for dealing with him

racerone3 Invoice.jpg

(sorry Brian, I couldn't resist)

[wfo]

thats cheep..mine was more than that

[rocketman17joe]

Thanks for the info the left shifter pin was d shapped i ordered 2 new ones from ri got them in two daye replaced all good.

merry christmas