Announcement

Collapse
No announcement yet.

lights install

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • #31
    how would i tie into the stock lights?

    Comment


    • #32
      You could always go into the back of the head light bucket and pick up your Hot wire there.
      Ether Tie into the wire or unhook the stock light and use the stock pig tail to test them out.
      It may just take a Spade wire end ?

      Comment


      • #33
        so just tie each positive wire on each led to the main hot wire for the stock lights?

        Comment


        • #34
          If your not going to use them with the LED then yes. That way your all set.

          Comment


          • #35
            so will i still be able to use the stock lights?

            Comment


            • #36
              If you tie into the same wire and leave them hooked up yes. But thy will come on with them all the time.
              Or you could just hook them up to the high beam side. You will need to look over your wiring real good to figure it out as I am not there to see what is what ?
              Do you have or can you get a wirering diagram ? That would help you out greatly !!

              Comment


              • #37
                my friend has that done. he got the led lights hooked up to the high/low beam switch. i will try and find one!

                Comment


                • #38
                  file:///C:/Users/lana/Downloads/2005-2006%20Foreman%20500%20Service%20Manual.pdf
                  the wiring diagrams are right at the bottom and scroll up a bit. i could not copy a picture sorry.

                  Comment


                  • #39
                    copy the link and paste it into another tab and go to page 437

                    Comment


                    • #40
                      decision is made im going to use the toggle switch..the ratings are at post #29 so could someone tell me if that switch will work?

                      Comment


                      • #41
                        What is the amp rating on the switch ?

                        Comment


                        • #42
                          i just bought a toggle switch and it says 10A 125VAC
                          15A 12VDC
                          THESE #S ARE FOR EACH PRONG(ONLY 2 PRONGS).
                          the numbers say that on top of each prong.

                          Comment


                          • #43
                            Ok so your switch is rated at 15 amps. Now Your lights will have a amp rating also. So add the two light amp ratings together and if it is below 15 amps your good to go !
                            I am sure it will be ok as I sell just regular toggles all the time with the LEDs I sell at work.

                            Comment


                            • #44
                              it says on the box 27 watts. is that for each or two of them together? it says there a 6 three watt leds in each one.

                              Comment


                              • #45
                                Watts are Not Amps. You need to se what the AMP DRAW is per light.

                                Comment

                                Working...
                                X